Skip to main content
Note: The Airform Thermostat should be installed after the Indoor Unit(s) and Outdoor Unit(s) have been installed and tested for heating and cooling operation.

​
Parts You Will Need

For wall mounting:
  • Screw Driver
  • Drill & Drill Bit
  • Level
  • Pencil

​
Prepare The Wall Mounting Location

  • Before mounting the wall mount bracket, find a suitable location on the wall for the Thermostat.
Look for a location where the temperature is most representative of the ambient room temperature and has no hazards within the wall.
  • Decide how you will mount the wall bracket to the wall:
  • Install A: Screws with wall anchors (recommended)
  • Install B: Adhesive (provided in-box. Adhesive should only be used for painted drywall, glass, and metal.)
  • Using a level, pencil a small horizontal line on the wall where you intend to place the Thermostat. We recommend mounting the Thermostat anywhere from 3 to 5 feet from the floor.
If installing near a light switch, center the Thermostat with the light switch, and place it about 1.5-2.5 inches away from the switch for a cohesive look.
Follow the instructions below on the following pages based on your chosen wall mounting:

​
Install A: Screw-Mount to Wall with Pre-Installed In-Wall Wiring

  • At the center of your horizontal pencil line, using a ½ in. drill bit, drill a hole into the hollow of the wall.
  • If you are not installing directly into a stud, line up the wall mount to the horizontal line, and mark the screw locations using the provided wall mount. Use a ⅛ in. drill bit to drill pilot holes at the marked locations. Now push the drywall anchors into the holes.
  • Using suitable in-wall wiring, fish the power wire from your intended power source location and through the ½ in. hole you drilled. Fasten the wires with tape to prevent them from falling back into the wall.
  • Pull the wires through the large center hole in the Thermostat wall mount, so that the flat side of the wall mount is positioned against the wall.
  • Use the horizontal line indicators on the wall mount to align it to your horizontal pencil line; mark the locations of the screw holes on your wall. Ensure that the Airform logo is right side up.

​
Install B: Adhesive Mount with Inbox Power Cable

  • Step 1 here